Cemimax Dl33 Leveling Compound (20kg)

Special cements, mineral fillers, polyvinyl-acetate-copolymers, flow agents and additives.

• Easy apply
• Quick setting
• Superior flow – fast application
• Flexible – hand mix or pump application
• Very economic
• Interior use

Compressive Strength
After 1 Day Approx. 15mpa
After 7 Days Approx. 20mpa
After 28 Days Approx. 30mpa
Tensile Bending Strength
After 1 Day Approx. 4mpa
After 7 Days Approx. 5mpa
After 28 Days Approx. 5mpa

Pack-size: 20kg/bag
Drying time: 2 hours
working time: 20-30 minutes
Shelf-life: Min,12 Months
Coverage: Approximately 5-6m2 at 3mm thick
VOC Level: <0.5 mg/m3

DL33 can be applied from 1.5mm to 70mm thickness in one application.

• The substrate must be sound, free from cracks, dry, clean and free from materials which would impair adhesion.
• Test the substrate according to applicable standards and
  report any deficiencies.
• Brush, abrade, grind or shot-blast any weak surface sections
  or areas which eill not accept adhesion
• Thoroughly vacuum to remove loose material and dust.
  According to type and condition of the subfloor, suitable
  primer.
• Allow primers to dry thoroughly.

1.Put 4.2-4.5 litres of cold clean water into a clean container.
Sprinkle in the sack contents (20kg) whilst stirring briskly and
mix to a thick-fluid. Lump-free consistency. Use a drill or mixer
fitted with a Mixing Paddle. Do not mix too thinly. For best flow
ability of product, mix for 3 mins.
2.Pour the mixture on the area to be applied, spread the material
uniformly to Required thickness using toothed rake. It is the next
step to remove entranced air by particular roller.
3.Drying time at 20℃ is approx 24 hours. Abrading using 40-60
grit sanding paper improves both the surface quality and the
absorbency. Poor air-flow and lower temperatures will signifi-
cantly affect drying times.